[SOLVED] Altium designer IC with two part in board placement

[baby_2]

Hi,
I have selected a two part component IC as you can see below

and I have set both of their name the same : U1A , U2B but after I update my pcb I have seen two different ICs!!! How can solve this problem?

 

[KlausST]

Hi,

I'm not familiar with Altium...

But you say U1A and U2B..
this is confusing, because "U1" designates the IC in board
And "A" and "B" designates a sub circuit within an IC.

So if both is in one IC I expect "U1A" and "U1B" (no U2_)

Klaus

 

[baby_2]

Sorry it was a mistake in typing.
I named them U1A and U1B

 

[Alexsander]

Hi,
I have selected a two part component IC as you can see below
View attachment 137600
and I have set both of their name the same : U1A , U2B but after I update my pcb I have seen two different ICs!!! How can solve this problem?

Hi Baby_2, Alexsander from Altium here. I'm actually not sure about this one. Usually Altium Designer will pick a single footprint for your multipart component. check to make sure that everything is properly named and run the ECO again to update your PCB. If that doesn't work give support a call and they'll help you out. Its better to call support and get an answer in a few minutes rather than spending an hour or so trying to make it work.