mcggoal
Newbie level 2
- Joined
- Aug 16, 2009
- Messages
- 2
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- shenzhen,China
- Activity points
- 1,291
Hi,
I am beginner with cadence, while I draw the power line, I meet a problem:
The DRAM has 9 power pins, while I use 1 power wire to connect them, there is an error:
ERROR(SPCOCD-150): Signal connected to pin has incorrect width.
The pic is in attachment.
And I found in the demo, there is an "9=1" mark nearby, which can solve this problem, So I
want to know how to set the "9=1" attribute?
Thanks!
I am beginner with cadence, while I draw the power line, I meet a problem:
The DRAM has 9 power pins, while I use 1 power wire to connect them, there is an error:
ERROR(SPCOCD-150): Signal connected to pin has incorrect width.
The pic is in attachment.
And I found in the demo, there is an "9=1" mark nearby, which can solve this problem, So I
want to know how to set the "9=1" attribute?
Thanks!