After ADS, what's next?

[crystal]

After simulation using ADS, I understand that we have to do layout for ASIC.

What if I'm going for PCB, which software should I use? Protel? Cadstar? Good enough for RF circuit? Anyone can help with this flow?
I've seen people doing device like coupler but not circuit.
Any help is useful especially those in M'sia.

 

[khouly]

after @DS simulation
u can use the layout editor in @DS and complet ur steps or begin with any tools in PCB u have
i think there is a link between @DS and ment0r

khouly