dili Neo
Junior Member level 2
- Joined
- Aug 21, 2012
- Messages
- 20
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Activity points
- 1,405
in ads schematic I placed an amplifier and imported S parameter(from an .s2p file) to the amplifier and did S-parameter simulation after doing 50 ohm terminations.I got S21 as in data sheet.Then I placed an amplifier in schematic and imported s parameter(from an .s2p file) and placed a 50 ohm as load and and connected P_1 tone source and did ac simulation in same freq range and plotted 20*log(mag(vout/vin)).But it is different from S21 plot in data sheet.why is it so??How can measure gain in such a set up?
vout
vin:i/p voltage of ampr
thanks in advance
vout
vin:i/p voltage of ampr
thanks in advance