DoYouLinux
Advanced Member level 4
- Joined
- Sep 26, 2007
- Messages
- 113
- Helped
- 3
- Reputation
- 6
- Reaction score
- 5
- Trophy points
- 1,298
- Activity points
- 2,152
Hi all,
I have just found some strange about placing port in Momentum layout. As seen from the picture, there are two ports where one port (blue) can snap to Metal 1 (blue), but the other port (orange) cannot snap to Metal 2 (orange). Not matter how large I zoomed to place the port to Metal 2, I could not make that port to snap to Metal 2. I tried to turn on every snap mode, but could not succeed. As seen, both Metal 1 and Metal 2 are on grid.
Anyone has seen this issue before ? As described from Momentum document, it says that even port is not snapped, it will snap automatically to the closest structure in the simulation, but not in the layout ...... Is this true ?
Thanks a lot
DYL
I have just found some strange about placing port in Momentum layout. As seen from the picture, there are two ports where one port (blue) can snap to Metal 1 (blue), but the other port (orange) cannot snap to Metal 2 (orange). Not matter how large I zoomed to place the port to Metal 2, I could not make that port to snap to Metal 2. I tried to turn on every snap mode, but could not succeed. As seen, both Metal 1 and Metal 2 are on grid.
Anyone has seen this issue before ? As described from Momentum document, it says that even port is not snapped, it will snap automatically to the closest structure in the simulation, but not in the layout ...... Is this true ?
Thanks a lot
DYL