Hello, I am trying to do an em cosimulation in ADS but when I run the simulation it says that it is finished with errors like in the screenshot below. It says that matrix is singular beween nodes or branches.... but I cannot find these nodes in my layout. Can you help me?
These errors are coming from an active model.
There might have few causes. Either model itself has some problems OR when it's been used with EM simulated board/substrate some convergence errors occur.
OR both..
Nobody can say something without knowledge of simulation setup.
I recommend you to check the board simulation results first, you shouldn't see any weirdness.
These errors are coming from an active model.
There might have few causes. Either model itself has some problems OR when it's been used with EM simulated board/substrate some convergence errors occur.
OR both..
Nobody can say something without knowledge of simulation setup.
I recommend you to check the board simulation results first, you shouldn't see any weirdness.
Sorry but this layout is a nightmare.
You have to work on it and Momentum cannot simulate correctly this layout because it has many fundamental errors.( Ports, Transmission Lines) etc.
Sorry but this layout is a nightmare.
You have to work on it and Momentum cannot simulate correctly this layout because it has many fundamental errors.( Ports, Transmission Lines) etc.