S2m
Newbie
- Joined
- Dec 13, 2024
- Messages
- 1
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1
- Activity points
- 8
Hello all,
I’m trying to create a 3dB power divider in order to create a 1x2 patch antenna in ADS. Currently I have the following schematic below:
For the MLIN (TL6 and TL7) these components come up highlight and mention that they’re not in the schematic, I’ve kept the values as the 70.7 ohms linecalc. How can I fix this? With out these components it works fine and s parameters are good, but they’re just too close together and the patch antenna would overlap if I don’t add extra MLIN before the Bends.
I’m trying to create a 3dB power divider in order to create a 1x2 patch antenna in ADS. Currently I have the following schematic below:
For the MLIN (TL6 and TL7) these components come up highlight and mention that they’re not in the schematic, I’ve kept the values as the 70.7 ohms linecalc. How can I fix this? With out these components it works fine and s parameters are good, but they’re just too close together and the patch antenna would overlap if I don’t add extra MLIN before the Bends.
