Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Reply to thread

Message

Hello,

I'd like to move the center point of circle via a cell parameter. But unfortunately I can't enter the parameter name as one center point coordinate. The warning says "Not a number".
How is it possible to set the center point by using a cell parameter?

[ATTACH=full]198364[/ATTACH]

[QUOTE="ICRF, post: 1790626, member: 693360"] Hello, I'd like to move the center point of circle via a cell parameter. But unfortunately I can't enter the parameter name as one center point coordinate. The warning says "Not a number". How is it possible to set the center point by using a cell parameter? [ATTACH type="full"]198364[/ATTACH] [/QUOTE]

Verification

Welcome to EDAboard.com

Reply to thread

Part and Inventory Search

Connect with us

Online statistics

Forum statistics