hi all,
how can I solve this in ADS 2021? every time it happens when I load "design guide" -> "amplifier" -> "DC and bias point simulation" -> "bjt" or FET
I remember to have deleted (before the error) some cell (schematic) that have been loaded into my workspace when I loaded this degin guide wizard, I was supposed that deleting some schematics (that the design guided added to my workspace) from my workspace could not delete the original but instead it happened!! (maybe I didn't archived the project?)
here is the error: "
ERROR: (dgStudio.ael line 21945, column 21 in de_get_views_in_library_cell)
Failed to get views in library cell "powerampdg:BJT_IV_Gm_PowerCalcs".: Failed to get data for cell "powerampdg:BJT_IV_Gm_PowerCalcs".: The cell does not exist."
neither a fresh installation resolved the issue!
I would need of some files!
many thanks
--- Updated ---
ERROR: (dgStudio.ael line 21945, column 21 in de_get_views_in_library_cell)
Failed to get views in library cell "powerampdg:fet_81xp".: Failed to get data for cell "powerampdg:fet_81xp".: The cell does not exist.
There is no problem with ADS2024. I have downloaded the DK from Ampleon and there isn't FSL block, It works standalone. I guess there is a problem in your ADS installation since this error appears in every time you open a schematic.
I tried to reproduce the configuration. When you start the DesignGuide, ADS creates a new directory "designguide files" at the same location where you stored your workspace. In that designguide files directory, you will find a directory "powerampdg" with the powerampdg library that your message complains about => I think this library is corrupt/incomplete in your case.
I would delete the incomplete/corrupt "powerampdg" directory, so that ADS will re-create it properly when you start the DesignGuide.
Did you ever resolve this issue? I am facing the same thing. I deleted some schematics that came with a library and now the design library doesn't seem to work, even after uninstalling and reinstalling ADS. I'm at a loss here. How did you proceed?
Did you ever resolve this issue? I am facing the same thing. I deleted some schematics that came with a library and now the design library doesn't seem to work, even after uninstalling and reinstalling ADS. I'm at a loss here. How did you proceed?
Find the "designguide_files" document, and delete the files which in it. then return the ADS, open the disgnguide which you want and wating the software unzipping it again.
Did you ever resolve this issue? I am facing the same thing. I deleted some schematics that came with a library and now the design library doesn't seem to work, even after uninstalling and reinstalling ADS. I'm at a loss here. How did you proceed?