Adding practical "inductance" to probe feed port in IE3D

Status
Not open for further replies.
E

Er Swapnil Parihar

Newbie level 4
Joined
Jul 31, 2013
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
32
I have been designing a Radar planar antenna at low frequency. The height of the substrate is h=15mm. So the practical antenna is showing an added +34j (50 ohms matched value) inductance then the simulated results. To model this antenna correctly in software (IE3D) i need to add this inductance to port .....
How can i do that in software?? Please Please help:roll:
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…