active antenna attenuator, what value of pot to use?

Status
Not open for further replies.

neazoi

Advanced Member level 6
Joined
Jan 5, 2008
Messages
4,157
Helped
13
Reputation
26
Reaction score
15
Trophy points
1,318
Location
Greece
www.microwave.gr
Activity points
37,198
Hello, I have built this antenna preamplifier and it works nice
**broken link removed**

I would like to insert a pot between the antenna and C1 in a voltade divider configuration, to achieve input attenuation when needed. I have tried a 10K pot and it works nice, but is that the right value I should place there?
 
An input potentiometer isn't a good idea. Assuming that the input transistor isn't yet overloaded, you can use a potentiometer in place of R3, connecting C3 to the wiper.
 
Reactions: neazoi

    neazoi

    Points: 2
    Helpful Answer Positive Rating
An input potentiometer isn't a good idea. Assuming that the input transistor isn't yet overloaded, you can use a potentiometer in place of R3, connecting C3 to the wiper.

Why an input potentiometer is not a good idea? Maybe because of impedance problems?
If going as you desctibe, strong out of band (and adjacent) signals will overload the fet and rise many unwanted signals.

Saying so, I have not noticed any difference in the signal strength with the potentiometer in place (turned to max sensitivity) and when leaving this out
 
Last edited:

The potentiometer will add noise and possibly load the antenna, depending on it's impedance. To find a better value than the original 10k, the antenna impedance should be known, too.

Because you most likely don't know it, keep the 10k potentiometer or add a local/DX attenuator switch in front of the amplifier.
 

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…