Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

A problem with ADXL202

Status
Not open for further replies.

saeid4020

Newbie level 3
Newbie level 3
Joined
May 24, 2006
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,298
Hi
I am doing a project by ADXL202 and I want to measure "tilt angle" of X & Y axis with PWM output of ADXL202.
but when I rotate my board at direction of X , tilt angle of Y axis change about 5 degrees (in range of 90 degrees of X axis)!
what is problem?
thanks for your attention.
 

Any output might influence any other output in order of 20%.

I.e. If you're measuring 1.0G on X axis, the Y axis ( that "really" measures 0G ) might out 0G to 0.2G

A friend have many and many times measured that, and I remember I already have seen this 'spec' writted on a datasheet.
 

thanks for your reply
but I have confronted another problem:
resolution of my Y axis in range of -70 to -90 degrees decrease too much.
what is problem?
is it natural or unnatural?
 

Hi !

Do you remember that output is = sin ( tilt angle ) ?! :D
 

HI
Ok
it is TRUE but Does that mean I can't improve resolution in this range? :cry:
 

Can you give me an example ?!
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top