A-3000 Master Guard UPS

Status
Not open for further replies.
K

khaliddelta

Newbie level 2
Joined
Jun 13, 2014
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
9
I have A-3000 Master Guard Siemens UPS, after replacement of batteries they given Beep on Mains after 1 Minu
 

Check voltage on all batteries. If one is very low, then the UPS may think the pack is faulty. It may decide they cannot be charged. So it beeps an error.

The opposite case is possible (though unlikely), that one or more batteries is too high a voltage.

There is also a chance the UPS needs to be reset. The steps may be given in the instruction manual.

Perhaps you can find more info in the threads listed at the bottom of this page.
Or, try a search at this message board, on 'Siemens' or "'A-3000', etc.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…