9V Battery clips (surface mount)

Status
Not open for further replies.
J

Jester

Full Member level 6
Joined
Aug 18, 2012
Messages
377
Helped
7
Reputation
14
Reaction score
7
Trophy points
1,298
Location
.
Visit site
Activity points
4,754
Hi,

I have been searching without much luck for 9V battery terminals.

Must be SMT

I did find this Keystone clip: https://www.digikey.ca/product-sear...attery-holders-clips-contacts/393250?k=534-68

That is the orientation I'm looking for, however that part is described as free hanging, I would prefer just the clips without the fibre holder (space limitations).

Anyone know where I can get just the clips? or at least intended for SMT mounting

Thanks,

Jester

- - - Updated - - -


Found them Keystone 269
 

If the battery clips are surface mounted as you intend, then removing the battery will result in the clips being levered off the board. Either use the clip as shown on wires or use a bracket with springs to make contact with the battery terminal.
Frank
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…