9V Battery clips (surface mount)

[Jester]

Hi,

I have been searching without much luck for 9V battery terminals.

Must be SMT

I did find this Keystone clip: https://www.digikey.ca/product-sear...attery-holders-clips-contacts/393250?k=534-68

That is the orientation I'm looking for, however that part is described as free hanging, I would prefer just the clips without the fibre holder (space limitations).

Anyone know where I can get just the clips? or at least intended for SMT mounting

Thanks,

Jester

- - - Updated - - -

Hi,

I have been searching without much luck for 9V battery terminals.

Must be SMT

I did find this Keystone clip: https://www.digikey.ca/product-sear...attery-holders-clips-contacts/393250?k=534-68

That is the orientation I'm looking for, however that part is described as free hanging, I would prefer just the clips without the fibre holder (space limitations).

Anyone know where I can get just the clips? or at least intended for SMT mounting

Thanks,

Jester

Found them Keystone 269

 

[chuckey]

If the battery clips are surface mounted as you intend, then removing the battery will result in the clips being levered off the board. Either use the clip as shown on wires or use a bracket with springs to make contact with the battery terminal.
Frank