hi guys
i have confused by setuping port type in @DS momentum. by help document, i can define the port as differential type , and associate each other. but i can't do it with my dipole antenna, illustrating as following:
i can simulate it with internal port type, but i can't decide which type should i use?
another question, this RFID is encapsuled with PVC, and the antenna is printed on PET(a very thin "paper"), i set the substrate as follow:
////freespace////
////PVC/////
///stip cond///
///PET////
///PVC///
///freespace///
am i right?
yes your right, but port setting as follow;
in dipole antenna design port_1 "Port Type" ought to internal, port_2 "Port Type" setting to "Ground Refernce"...."Associate with port number" Assign to "1" (<= port_1)..
you can run it...
thanks