Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

9 coil common mode choke for 8 channel comms emitter?

C

cupoftea

Advanced Member level 6
Advanced Member level 6
Joined
Jun 13, 2021
Messages
3,058
Helped
62
Reputation
124
Reaction score
139
Trophy points
63
Activity points
15,957
Hi,
We have eight low frequency (~1khz) 2-wire comms channels going off a PCB. They all share the same ground.
We wish to do a common mode choke for them. (to stop their wires acting like EMC_fail emitters.)
So we will just wind a 9 coil common mode choke on a torroid.
Is there any foreseeable situation, where doing so could make common mode emissions worse?
 

LaTeX Commands Quick-Menu:

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top