[SOLVED] stepeer motor with arduino control various angle

[maxim10373]

I am using a Nema 34 stepper motor and DM556 driver with Arduino
And a single push button is also used on the input. What is needed now;

A full rotation (360 degrees) should be divided into eight parts

when push the button motor run 45 degree angle then stop,
When push the button again ; motor run 90 degree angle then stop.
This is followed by 135-180-225-270-315-360 degree angles.
That's enough.

Can someone help me to make a sketch

maxim10373

 

[KlausST]

Hi,

there are libraries, ready to use software, tutorials, example code, documents, explanations, videos ...
thousands of sources

What information do you need that is not already given?

Don´t expect anyone to do your job (for free). Don´t get me wrong: we don´t see any effort on your own (because you did not tell)

Klaus

 

[danadakk]

Take a look at this thread and some of the links to examples in it :

How to control nema 34 motor with arduino board( project guidance and help)

conveyor system is run by using lead screw so stepper motor I am using My question stands. when a signal is send to arduino motor rotates 360 and conveyor runs by 5mm How can you be sure that the motor rotates 360? You may send instructions to the driver to achieve this, but without a...

forum.arduino.cc

How can I use stepper for specific degree?

I use Arduino and I'm beginner. I use the code below, but I don't understand what stepper.step(num) and STEPS in Stepper stepper(STEPS, 2,3,4,5) are, and I want to use stepper for specific degree a...

arduino.stackexchange.com

Controlling stepper motor nema 34 using AccelStepper library

Hello all, i have some question about stepper motor that i use now. i try using accelstepper example to try constant speed of this motor. i set the motor about 2000 step/rev. i want to know what maximum speed that i can run using this type of motor. now my coding are like this. #include...

forum.arduino.cc

Regards, Dana.