Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

4011 CMOS touch switch - problem with long touch

Status
Not open for further replies.

tkb5416

Newbie level 4
Newbie level 4
Joined
Nov 22, 2009
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,333
4011 CMOS touch switch

I am using 4011 CMOS as touch switch to control my microcontroller that is linked to motor driver L293D as on/off.

When I touch for the first second, the motor will activate for 2seconds. It works fine if I am touching it for more than 2 seconds.Let's say,if I touch for 3seconds, then the motor will activate for 3 seconds.

Do u have any ideas what is the main cause of this problem? If do, can u provide me the solution?

Thank you.
 

You may need to use J-K flip flop with J and K are connected together.
When you touch the input of the J-K flip flop the motor will be activated and when you touch it again it will be deactivated.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top