penoy_balut said:3310 can be easily controlled thru FBUS , you need FBUS cable, any microcontroller with UART capable of 115.2 kbps, some knowledge about PDU and FBUS protocol (plenty on the net) and programming.
glenjoy said:Are you sure there is plenty on the net of FBUS programming protocol?
It is very good place for your project. But it is very difficult to complete your project without helper. I think a lot of people will help you.auto_mitch said:**broken link removed**
penoy_balut said:3310 can be easily controlled thru FBUS , you need FBUS cable, any microcontroller with UART capable of 115.2 kbps, some knowledge about PDU and FBUS protocol (plenty on the net) and programming.
penoy_balut said:penoy_balut said:3310 can be easily controlled thru FBUS , you need FBUS cable, any microcontroller with UART capable of 115.2 kbps, some knowledge about PDU and FBUS protocol (plenty on the net) and programming.
or you can also wire FBUS TX and RX pin directly to the microcontroller, put a 10k resistor as precaution, i am using zilog encore with VDD same as that of 3310
glenjoy said:better post your codes here, how to read sms, how to send, how to delete... etc...
It is a far more better help than saying you had created something, we are not looking forward for you to post your whole code, the routines to access the basics of the 3310 is already enough.
penoy_balut said:glenjoy said:better post your codes here, how to read sms, how to send, how to delete... etc...
It is a far more better help than saying you had created something, we are not looking forward for you to post your whole code, the routines to access the basics of the 3310 is already enough.
FBUS has been discussed on many sites, you need to modify several bytes particular to your application like message length, your service provider's message center, destination number, time stamp, message in PDU, padding byte and XORed checksum.
No.Does FBUS works in the same time with MBUS?
Yes.Can i choose which one i want to use?
No.Does 3310 support the text format?
No.The FBUS baudrate is 115200bps,could it run at lower baudrate like 9600bps?
I prefer to communicate to 3310 using VB.Could u please give some instructions to have a communication between pc and cell phone?
bbbb said:Hi
1. Look in the following website; you can find RX and TX pins on the connector.
https://pinouts.ru/CellularPhones-P-W/erics_t28_pinout.shtml
2. another solution is to use the DATA CABLE of the phone set and connect it to you uC baord (which must have a TTL to RS232 converter as well). Now you uC board acts as PC and it can be connected to many phones using different DATA cables.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?