3 layer simulation in ADS

Status
Not open for further replies.
B

beaulah

Newbie level 5
Joined
Jan 27, 2008
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,354
hi ...i have to model a 3 layer PCB.....my layers should be in the following way....
free space
cond1(micro strip)
substrate
ground
substrate
cond2(microstrip)
free space
how to model this in ADS momentum and i also want coupling between cond1 and cond2 .....how to define the layers.....
 

If you put an ideal ground plane between the two substrates, there will be no coupling between them.
You have to put slots on the ground plane or vias between cond and cond2
Good luck
 

    B

    beaulah

    Points: 2
    Helpful Answer Positive Rating
ideal ground plance ( between two layers ) is not posible to model in ADS.

It will exit either on top side or bottom side.

I suggest more study on ADS momentum manual on substrate definition,layers etc.
 

    B

    beaulah

    Points: 2
    Helpful Answer Positive Rating
kspalla said:
ideal ground plance ( between two layers ) is not posible to model in ADS.

It will exit either on top side or bottom side.

I suggest more study on ADS momentum manual on substrate definition,layers etc.
Click to expand...

You can create a slot type layer between the two signal planes, then the slot type layer will be considered to be an infinite ground plane.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…