2nd order High Pass butterworth filter

Status
Not open for further replies.

imrankhanPNU

Member level 1
Joined
Feb 21, 2018
Messages
34
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Visit site
Activity points
461
Hello,
Could anyone review my 2nd order Butterworth HPF design? I have mentioned design details along with schematics and initial results.

Design specifications for 2nd HPF: Cutoff frequency= 100Mhz, Design method: by considering equal component, Input signal= 10V,120MHz, sinosidal.

Design specification for OPAMP: Slew rate= 5V/usec , CL=10pF, ICMR+= 4.5V, ICMR-=1.5V , Vdd=5V, GBW>=5MHz, W/L ratio is mentioned with each transistor.

According to the calculations, it should work but I do not know where I am making mistakes...

Thanks
 

Attachments

  • 1.JPG
    96.4 KB · Views: 153
  • 2.JPG
    155.9 KB · Views: 159

Sort by date Sort by votes
Something really amiss if you are doing this at 100 Mhz with 5 Mhz GBW G elements ?
Same comment applies to G element slew rate of only 5V / microsecond. That does not
jive with :




What am I missing here ?


Regards, Dana.
 

Upvote 0 Downvote
To check performance of your rolloff curve, apply a sweeping sine wave say, from 1/10 of spec frequency to 10x spec. Output should resemble this simulation of 1st order filter.
Naturally your rolloff curve ought to be steeper since yours is 2nd order.

Notice with my larger R value, less current is gobbled from the source.

 

Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…