Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

J-Link can not recognized my board ?

Status
Not open for further replies.
B

bianchi77

Advanced Member level 4
Advanced Member level 4
Joined
Jun 11, 2009
Messages
1,313
Helped
21
Reputation
44
Reaction score
20
Trophy points
1,318
Location
California
Activity points
9,442
Guys,

I tried to connect J-link to my STM32 board,
Does anyone know why J-Link can not recognized my board ?

Which jumper setting should I consider well ?

Please see the circuit,

Thanks
 

Attachments

  • STM32F103V.pdf
    662.8 KB · Views: 165

can I use JTAG for power supply on Pin 19 ?

- - - Updated - - -

is it possible if my chip (STM32 chip) burned ? overheat from my solder ? or just VDDA issue ?
 

Why not use the SWD interface
Very simple

 

Thank you guys, it's working now...I tested for the code....no problem
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top