Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to program Proasic 3 without flashpro programmers?

Status
Not open for further replies.
J

jatink007

Junior Member level 3
Junior Member level 3
Joined
Mar 12, 2010
Messages
31
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
Pune
Visit site
Activity points
1,489
how to program the proasic 3 or igloo or smart fusion series FPGA by microsemi without flashpro programmers......or even by direct c...i mean by using either some parallel port or USB.......if by direct c then how? i am using a PIC on the board...18F87J50
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top