balamani
Member level 1
Dear All,
I need to measure s11 and s12 of a filter. Freq range is 41GHz.
Do i need to provide provision for 1.85 mm connector in the gerber file for fabrication?
I have not added the two holes of 1.85 mm connector in the simulation. Will the measurement results vary much ?
Also, the feed trace width is approx. 1mm only and will the 1.85 mm connector make proper contact with the feed trace?
kindly clarify.
I need to measure s11 and s12 of a filter. Freq range is 41GHz.
Do i need to provide provision for 1.85 mm connector in the gerber file for fabrication?
I have not added the two holes of 1.85 mm connector in the simulation. Will the measurement results vary much ?
Also, the feed trace width is approx. 1mm only and will the 1.85 mm connector make proper contact with the feed trace?
kindly clarify.