0805 resistor across the 230VAC post bridge DC bus?

Status
Not open for further replies.
C

cupoftea

Advanced Member level 6
Joined
Jun 13, 2021
Messages
3,059
Helped
62
Reputation
124
Reaction score
139
Trophy points
63
Activity points
15,963
Hi,
We have been sent in a customers failed SMPS development, and asked to get it working.
It’s a 220W 230VAC offline PFC’d supply.
The PFC uses an 0805 across the post rectifier bus as attached.
In my book, 0805 is 150V max….but they say that since the DC bus is regularly going to zero, its allright. Do you concur with their declaration?
(my apologies "MOUT" pin should read "IAC" pin in the attached)
 

Attachments

  • 0805s.jpg
    151.5 KB · Views: 136
  • IAC_fromu.zip
    1.1 KB · Views: 126
Last edited:

Sort by date Sort by votes
If peak voltage is above the peak voltage of the part then they're likely riding their luck. The resisters arn't the same value either so the is likely that 383k has most of the 300+ Volts on it
 
Upvote 0 Downvote
Last edited:
Upvote 0 Downvote
A single resistor will fail in short order, the normal solution to this problem is to put three or more equal value resistors in series.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…