0.35um technology paprameters in PSPICE

Status
Not open for further replies.
S

simplsoft

Full Member level 2
Joined
Nov 24, 2014
Messages
127
Helped
0
Reputation
0
Reaction score
0
Trophy points
16
Visit site
Activity points
1,045
Hello can anyone help in PSPSICE software. I am using PSPICE ORCAD 10.0 VERSION I want to simulate a filter circuit using 0.35um technology. What level do I have to use for ORCAD 10.0 PSPICE software. I am using level 3 but I could not get the accurate results.
In some forums its mentioned that use level 7 what do I ahve to do?
 

Thanx for ur reply. But in this page level 49 is mentioned. Do i have to change level 49 to 7? I am only copy pasting the model parameters only not the whole like temperature etc? Do I hv to copy paste from start to end in model editor of PSPICE

erikl said:
Try SPICE Level 8 models , which I pointed to in this post, in this thread of yours.
Click to expand...
 

simplsoft said:
... in this page level 49 is mentioned. Do i have to change level 49 to 7?
Click to expand...

To 8. It is level 49 for HSPICE, ELDO & SPECTRE. For SPICE 3f5, UTMOST and PSPICE it is level 8. Change it.

simplsoft said:
Do I hv to copy paste from start to end in model editor of PSPICE
Click to expand...

I think so, I've never worked with PSPICE myself. Just try it. If PSPICE doesn't know some parameters, it will tell it with a warning - just ignore it.
 

Noticed that you are using ORCAD 10.0 version, which is too old. I don't think level 8 would work with that.
You should be using newer version of orcad.
 

thanx mvaseem. now i am using orcad 15.6. but still i am not getting the results. In some research article it has been mentioned that they have used level 3. plz help me what to do now
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…