Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

K type thermocouple Amplifier needed

Status
Not open for further replies.
baileychic

baileychic

Advanced Member level 3
Advanced Member level 3
Joined
Aug 2, 2017
Messages
728
Helped
56
Reputation
112
Reaction score
57
Trophy points
28
Visit site
Activity points
7,033
Hi,

Can somebody show a K-Type Themocouple amplifier circuit with cold junction compensation using general purpose OpAmp ?

I tried to design one using MCP6002 but it is not working. My temperature range is 0 to 450 degree C.

I will be reading the output of the amplifier using Arduino Uno.
 

I tried to design one using MCP6002 but it is not working.
Click to expand...

Won't blame MCP6002 for the failure, although you might choose an OP with lower offset and offset drift. Why not show your design?
 

This is the circuit I designed and it is working fine now.
 

Attachments

  • Thermocouple Reading A1.png
    Thermocouple Reading A1.png
    21 KB · Views: 751

Yes, basically O.K. As said, you would want to use a precision OP for the input stage. "Cold junction compensation" is a dummy yet, it should inject a temperature dependent voltage with 40 µV/K slope input related, respectively 10 mV/K after the preamp. Or use any available digital thermometer and perform the compensation in the digital domain.
 
HI,

Go to an Opamp manufacturer, they usally have interactive selection guides...or a distributor's web site.

Klaus
 

Hi,

The circuit of post#6 doesn't include an cold junction compensation.
Thus the output accuracy is wrong by the cold junction temperature.
And the output is as precise as the cold junction temperature.

All in all not a very precise measurement method.
Thus your Opamp doesn't need better specification than the method.

This means: you don' need an Opamp with better than 25°C or about 1mV
And the drift doesn't need to be better than 40 uV/K.

You can safe money by omitting the second Opamp, because it is useless in your circuit.

Klaus
 
Klaus can you provide a better circuit with MCP6002 with cold junction compensation ?
 

Hi,

I used a LinearTechnology device with analog output and a Maxim device with digital output. Both fairly accurate, but not cheap.

A special high precision Opamp usually isn't as cheap as a general purpose Opamp.

Circuits, discussions, application notes....are easy to find.

Klaus
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top