Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Questions about S22 calculation of frequency tripler in ads simulation

Status
Not open for further replies.
M

maxsidou

Member level 1
Member level 1
Joined
Aug 21, 2018
Messages
38
Helped
4
Reputation
8
Reaction score
3
Trophy points
8
Activity points
361
hello, i'm simulating one frequency tripler in ads using simplecoupler to calculate S11 and S22. As shown in the figure, port 1 injects a large signal of RFfreq, RFPwr and port 2 injects no signal. i use S11=HB.RF_refl[1]/HB.RF_in[1] to get the right S11, but S22=HB.RF_out[3]/HB.RF_outref[3] gives the wrong S22. I consider port 2 injects no signal and RF_outref[3] is the input power to port2 while RF_outref[3] is the reflected one. Could someone tell please where am I wrong? thanks for your response. Freq_tripler.png
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top