Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

LC at high frequencies

Status
Not open for further replies.
M

MobiNaz

Full Member level 3
Full Member level 3
Joined
Aug 11, 2010
Messages
163
Helped
5
Reputation
10
Reaction score
4
Trophy points
1,298
Location
SYDNEY
Activity points
2,432
Hi All,

I am curious to know why at high frequencies the inductors and capacitors are designed using transmission line? Why not use coils for inductors and parallel plate etc for capacitor. Does it have something to with the component size at high frequency?

Thanks in advance
 

Self resonance frequency of the coils and capacitors is an issue at higher frequency.In additional to, realizing very small values-especially for coils- is pretty difficult.
Quality factor is another issue,stray and body parasitic elements around the package are also serious constraints..
So, there are many reasons to use distributed components at very high frequencies.
 
  • Like
Reactions: covcst

    covcst

    covcst

    Points: 2
    Helpful Answer Positive Rating
I would suggest you to read a good textbook on RF basics.
LC or lumped-elements resonators usually cease to work above 200-300 MHz. They are replaced with coaxial and other TEM lines. Above ~3 GHz, hollow-pipe waveguides are better as they have a lower loss.
 
  • Like
Reactions: covcst

    covcst

    covcst

    Points: 2
    Helpful Answer Positive Rating
Thanks for replying guys!

jiripolivka@ Could please recommend a particular book explaining this thing in detail?
 

MobiNaz said:
Thanks for replying guys!

jiripolivka@ Could please recommend a particular book explaining this thing in detail?
Click to expand...

My college textbook for this high-frequency stuff was Microwave Engineering by David Pozar. It's pretty math intensive for the derivations, but a very thorough work up on the entire microwave engineering subject. Parasitic effects of devices aren't often covered in textbooks, but are left to be understood in the lab environment, as they vary from device to device and are highly frequency- and geometry-dependent.
 
Try Ramo, S., Whinnery, J.R., Van Duzer, T.: Fields and Waves in Communication Electronics, J.Wiley, N./Y/London, 1967.

All good books on RF and microwave techniques include important details.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top