Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to isolate between tracks in altium?

Status
Not open for further replies.
N

nxt_

Member level 4
Member level 4
Joined
Aug 16, 2010
Messages
69
Helped
4
Reputation
8
Reaction score
4
Trophy points
1,288
Location
Egypt
Activity points
1,834
Dear all,
Greetings, i would like to know how to isolate between tracks in altium 10 designer after finishing the pcb, i mean like in Eagle. (after you finish the routing and everything you just set the ratio and the program do the rest.) so i am asking how to do that in altium.

i am using photo resist technique as pcb manufacturing process. so i need to output file with holes ,vias,tracks including isolation to be printed.

Thanks.

---------- Post added at 01:38 ---------- Previous post was at 01:28 ----------

sorry its altium 09 not 10..
 

You can follow this guide for outputting your Gerbers from Altium. It also shows how to setup Clearances ( Isolation ) although this does need to be done before you route or you'll end up re-doing the layout where violation occur.

**broken link removed**
 

    V

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top