Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Cadence AWD problem in showing results

Status
Not open for further replies.
H

hesam_ahmadi

Junior Member level 1
Junior Member level 1
Joined
Feb 21, 2009
Messages
15
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Visit site
Activity points
1,371
Hi all,

I have a problem with Cadence AWD. some times when i do a simulation for a while, AWD shows only a little of wave form. for example when i do a tran simulation for 100m sec, AWD shows only 20m sec of it. i have tried X axes range both in auto and manual range.
the problem remains until i reset icfb.

Thanks for your answers,
Hesam
 

I'm not sure, but I had a similar experience with one of cadence' graphing tools a couple of years back, I think it was 20ms it wouldn't display past either, even though the sim ran successfully for much longer. The solution I found was to use another graphing tool, we have a few with our installation - I don't know whether they come as standard or whether they were add-ons our system admin guy installed.
Whether this will help in your case I don't know.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top