Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HELP: Non-manifold edges found for part ...

Status
Not open for further replies.
R

Rooney621

Newbie level 4
Newbie level 4
Joined
Sep 26, 2011
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,309
Hi all,
I'm an chinese student trying to use HFSS .
I created a model and I was trying to validate it but there should be some problems about it; does anybody know what this message "non manifold edges found for kongqiang1" means?
Please help me! Thank you very much!

---------- Post added at 15:45 ---------- Previous post was at 15:40 ----------

here is my model,please help me and tell me the fault~
 

Attachments

  • moxing2011.9.23.yiqiegehao.rar
    10.9 KB · Views: 162

Non-manifold means that some geometries have mixed dimensions and cannot be manufactured. In your case you have a 3D object which touches itself at a point or edge, look at the picture bellow:

2011-09-27_101719.png

2011-09-27_101911.png

Your circular tubes are to close to the the middle tube.Try to expand the the thin edge pointed with the red arrow in the picture. Use the "Clip pane" tool to show inside the object.
 
Thank you for your help! Thank you very much!!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top