Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PMDC Motor Controller....what should be input to it?

Status
Not open for further replies.
Hope this helps...............

Modified Electric Scooters - Help with Schwinn S-400.jpg

Throttle Connector

(red and black wires) = hall sensor supply voltage , potentiometer lo pin / hi pin (5V ± .5V)
(green and black wires) = hall sensor signal , potentiometer mid pin (0.5V - 4V, ± 0.5V)

Other wires not known.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top