Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Connect AGND and DGND in ADC

Status
Not open for further replies.
E

edabrduser

Junior Member level 2
Junior Member level 2
Joined
Dec 26, 2010
Messages
21
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,440
In ADC design, where should I connect the AGND and DGND. For example, the S/H block which is powered by analog supply must be driven with a digital clock so there two grounds must talk somewhere on chip to have a return current path right? Or we just rely on the assumption that AGND and DGND potentials are relatively close to each other and are connected somewhere outside the chip?
 

One of method is using magnetic bead to isolate them.
 
Ferrite bead isolation is done off-chip and is used to equalize the two dc ground potentials but keep the noise away right? So when the digital clock is switching the S/H, where will the return current path be?

leo_o2 said:
One of method is using magnetic bead to isolate them.
Click to expand...
 

Yes. Connect switching ground shortly and directly to supply ground and isolate analog ground with ferrite bead.
 

It depends of your layout. In any case the connection should be done shortly to pins of the ADC. If you want more detailed answer, please post your layout.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top