Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Decoupling circuit IC

Status
Not open for further replies.
J

jayce3390

Full Member level 6
Full Member level 6
Joined
May 22, 2007
Messages
351
Helped
29
Reputation
58
Reaction score
21
Trophy points
1,298
Activity points
3,287
Hi,

I want to mount a mmic GaAs amplifier operating at 30GHz on a board with a heat sink. The DC power supply will be connected to the die through a decoupling circuit composed of bonding wires/resistors and capacitors.
The drain voltage is 7V.
Can anyone help me to make a decision about the proper decoupling circuit ?
How to size the capacitor value ?
Should I use different capacitor values ?

Thank you
 

Check manufacturer's data for the advice you need. Or find a similar commercial MMIC die and instructions for it.
 
microwave 1pF + COG/100pF/0402 + NPO/10nF/0603 + 10uF/16V/A case
 
Right at the device, I'd stick a 100 pF microwave cap (like AT Ceramic's single-layer caps, Microcaps, etc). Similar to Tony, I'd stick a COG 100 pF cap in the DC bias circuit, then something more "bulk" beyond that, at the power input point to the board... 1-10 nF, etc, and bigger uF parts beyond that, depending on your on/off transition-time requirements.

Look at the device's manufacturer's datasheet or app note. The manufacturer should give you a recommended circuit implementation, especially when it comes to the bypass cap configuration.
 
tony_lth said:
microwave 1pF + COG/100pF/0402 + NPO/10nF/0603 + 10uF/16V/A case
Click to expand...

Thank you tony_lth, so using those values ensure a proper decoupling. Could you explain how did you do to get it ?

The impedance synthesized by this set of capacitors should be high in the operating frequency range? Right?
 

The impedance synthesized by this set of capacitors should be high in ......
Click to expand...
I don't understand your question? Do you mean the total cap is more than 10uF?
 
jayce3390 said:
Thank you tony_lth, so using those values ensure a proper decoupling. Could you explain how did you do to get it ?

The impedance synthesized by this set of capacitors should be high in the operating frequency range? Right?
Click to expand...

For decoupling caps, you want the impedance to be low, so the AC signals have a low impedance path to ground, and thus, back to their source. If you are operating at 30 GHz, then a 1 pF cap is Zc = 1/(jωC) = -j0.188 ohms. As C gets larger, the impedance gets smaller, which is what you want.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top