Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

testing the IPM 6MBP15rh060

Status
Not open for further replies.
A

Ahmed4444

Newbie level 6
Newbie level 6
Joined
Jul 4, 2011
Messages
12
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,355
HI
it's my first time to use IPM(6MBP15rh060) ,and i need to make 3 phase inverter .i use microcontroller to generate 6 pulses shifting by 60 degree , 6N136 optocoupler to interface MCU with IPM , 3 resistance Y connected as a load and VDC =200V . but it didn't work and not give the correct waveform of the output. View attachment REH983a.pdf
1- i use the same circuit as in example page 55 except for 3 resistance Y connected as a load is it any thing i miss?
2- how can i confirm that IPM not damaged? how can i do some test procedure fo IPM?

thanks in advance
 
Last edited:

It's difficult to confirm the IPM not damaged. But in my experience, when large IGBTs are damaged, they burst with large sounds and lightnings.
You should start with low voltage. I usually start with VDC = 20V or lower from external DC Power supply.
After check all waveforms, increase DC Voltage.
 
in my 1st experiment on IPM i found some burst sound but i think it from optocoupler i found 3 of them was damaged after replacement i can't confirm IPM damaged or not is it any simple circuit can i test the IPM ? it is little expensive in my country
if i should replace the IPM what is the best module i choose 6MBP15rh060 or IM21400-1 or PM20CSJ060 ?
 
Last edited:

Sorry, I use only IGBT modules (2in1 module), not IPM. I can't suggest other choise.

I had broken many IGBTs. May be, they turned on simultaneously with surge noise.
But I had never seen that optocouplers of drivers broke.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top