Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

buffer architecture aside from taper buffer that can drive clock for 1uF load

Status
Not open for further replies.
A

allennlowaton

Full Member level 5
Full Member level 5
Joined
Oct 5, 2009
Messages
247
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Location
Taiwan
Activity points
3,081
Hello EDA fellows,
I would like to ask your advises about any buffer architecture that can drive/provide clock for a very large capacitor (1uF).I tried to use taper buffer but it's extremely big (the MOS width reaches 20,000 already)...
Thank you.
 

Well, you're not going to get away from a big device if you want to drive
a big cap.

However you do want to play with anti-shoot-through when you get to
monstrous drivers.

Why there is a 1uF load on anything called a "clock", I couldn't imagine.
If it is many parallel loads then distributing predrivers could make
sense for several reasons.
 
I'm going to use that buffered clock for this pump circuit shown below:


C3 and C4 are 1uF capacitors.
 

Just use taper buffer. Please add dead-time control. Also pls be careful for ground bounce.
 
It is correct.
Ground bounce can be controlled by slew rate.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top