Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how can i solve this problem???

Status
Not open for further replies.

kabaleevisu

Advanced Member level 2
Advanced Member level 2
Joined
Apr 14, 2010
Messages
616
Helped
85
Reputation
170
Reaction score
81
Trophy points
1,308
Location
Chennai,India
Activity points
4,512
hi everyone ,
i get some problem when i opening PCB Editor ( cadence allegro 16.2 ) ,when the problem comes the pcb editor closed automatically .... please any one help for me
i posted the snapshot for problem

 

hi,

after the file closed go and check working folder file would be saved in.SAV format open this file now u can't save this design so go to file ->properties click lock database then u can save the design before editing to this design run database..
 
hi samym

i followed what u told but same problem will happen i post the DB DOCTOR REPORT

WARNING(SPMHDB-288): This database is locked for writing.
This database has been marked as a .SAV.
An attempt will be made to correct the problems.

Regenerating DRC
65 original DRC errors replaced by
65 current DRC errors.

Problems were corrected, database is no longer a .SAV!
0 warnings, 0 errors detected, 0 errors fixed.

Problems were corrected, database is no longer a .SAV!

Saved drawing E:/current project/power module design/board/PS-PMD-V2_1.brd.
 

hi,

first open the file then unlock (file -properties) then only u can save..at that time of saving delete .sav extension

---------- Post added at 11:47 ---------- Previous post was at 11:43 ----------

hi,

let me know did u get it?
 
hi normally i open the board file in allegro PCB design GXL when i get the problem now i opened in allegro PCB design XL

it is working when i follow your procedure

but if i open the saved file or any exiting board file in allegro PCB design GXL. same error occur what will do ???

if i open .dra file in allegro PCB design GXL i could not get error

any way thanks for your reply thank u so much !!!!
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top