Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

pcb trace thinner than SMA pin connector

Status
Not open for further replies.
K

kazim

Member level 4
Member level 4
Joined
May 26, 2006
Messages
77
Helped
6
Reputation
12
Reaction score
3
Trophy points
1,288
Location
Nowshera, Pakistan
Activity points
1,838
my sma connectro pin is 0.7 mm and my trace width is 0.4.
does any one have an idea how much siganl will i loose. and how can i eliminate this mismatch.
 

I dont have idea regarding the signal loss.
U cannot eliminate the mismatch but u can use a tear drop at the SMA connector pin to reduce the effect of mismatch.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top