Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

RF and Low-Frequency Analog Layout

Status
Not open for further replies.
K

kbryant

Newbie level 4
Newbie level 4
Joined
Feb 12, 2010
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,318
Hello!

On a PCB I have RF, digital, and analog sections.

RF section has a strong +5 dBm LO feeding the mixer operating in the MHz range.
The analog section consists of an active filter working in the kHz range with much weaker -15 dBm signals.

In PCB practice, power planes (and sometimes ground planes) of the analog and digital sections are usually partitioned and separated.

So my question is: should I separate the RF section from the digital and lower-frequency analog sections as well? Or can the RF section use the same power/gnd planes as the analog?
 


marce,

Thank you for the suggestions! I have skimmed through Ott's book and have a good idea of the isolation of the analog signals from the digital signals. In general though, do high-frequency analog components in the MHz range share the same power and ground with the lower kHz range analog circuitry?

marce said:
This is a hard one to realy answer without intimate knowledge of the circuit. I would reccomend some serious reading of books like Henry Ott, Howard Johnson, Ralph Morrison to name a few

https://www.semtech.com/images/datasheet/rf_design_guidelines_semtech.pdf
A good list of reccomended reading in the link below:
https://www.jlab.org/accel/eecad/pdf/050rfdesign.pdf
RF and Microwave: Design Challenges in PCBs - Mentor Graphics
Click to expand...
 

I have limited RF layout experience, so am hoping someone who is more experiences in this would provide some guidance. From the designs I have seen, the ground has been 1 contigous plane, the supplies were seperated for the RF and the other circuitry.
 

Thank you for your suggestions! I had a question, you mentioned you had the same ground plane for all sections... Did you separate the power plane or did you share the power as well?

rupeshchannawar said:
I have design the board with RF/ANALOG and Digital section. I have used same ground plane for all sections..and board is working fine... i will suggest u to separate RF and other low frequency parts...Refer below link...

**broken link removed**

https://www.qsl.net/va3iul/Files/RF-Microwave_PCB_Design_and_Layout.pdf
Click to expand...
 

yes, power plane is separated in each section.... RF Section is separated by Ferrite beads
 

On the boards I have seen/worked on had one contigous ground, the RF power isolated by a pi filter of cap-ferrite bead-cap.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top