Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Extractint timing and area informations from FPGA design

Status
Not open for further replies.

lahrach

Full Member level 3
Full Member level 3
Joined
Feb 6, 2009
Messages
170
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,285
Hi friends,

How can I extract timing and area information, using ISE 11.4 and Virtex-5

best regards
 

You can use the timing report in project navigator. There's planahead for timing analysis + floorplanning. And you can always look at what goes where in either planahead or fpga editor...
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top