Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

i have problem when i programming pic16f877a

Status
Not open for further replies.
I

iman86

Newbie level 3
Newbie level 3
Joined
Mar 13, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,299
hi everybody:wink:
i have got error message when i program pic16f877a
this message is "ERROR -> writing address 0x000000
writing :0x1683 Read : 0x3FFF "
please can anyone help me?

i don't know what is the problem.:?:
notice: i use winPic800 - v3.60.
thank you.
 

Try with fresh IC. This can happen if the IC is bad
 
  • Like
Reactions: iman86

    I

    iman86

    Points: 2
    Helpful Answer Positive Rating
i use new ic but i have got the same problem
if i read the chip before programming it by Winpic800, the program can read ic > and then when i try to program it, WinPic800 can program before ending other error message appear this message is " ERROR -. Writing address 0x002007
written : 0x2F89 Read : 0x2FCF"
thank you for all helping
 

I think u getting a verify error.... Wht type of programming u used in??? ICSP???/ if yes just remove all attached modules if any and try again.

This error occurs with bad microcontrollers

wht type of programmer u r used???
 

I use propic2 programmer:sad:
 

hd u tried with another controller????

did u try it as i said??? (Removing the attached hardware??? ) if ur using ICSP, remove the power supply line from the existing hardware

try it out and replay exact results......
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top