Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
you should know about c & a through understanding of 8051.
you can refer m.a.mazdi book for 8051. and you can practice the programs using KEIL free version available in ARM website.
i dont agree with you.. just because you get something free you are suggesting a very big controller for a learner... let him learn the alphabets and then learn the grammer....
dspic is too much for a begineer....
---------- Post added at 19:05 ---------- Previous post was at 19:02 ----------
As suggested get a copy of mazidi and start to learn.... if you dont know C concepts then get C book of yeshwanth kanetkar, or balaguruswamy and start..
There will be no specific embedded C textbook as this is compiler specific.... you may get a generic textbook but you have to learn it....
I don't see any point students learning out of date technologies. The PIC24 is powerful and flexible, easy to interface too and has lots of support for C programming in terms of APIs to help control its devices. Similar for the ARM. Most of our projects use PIC or Freescale 16bit processors, dsPICs for specialist multimedia projects (e.g. interfacing to Midi devices) and ARMs and PIC32s for more rigerous and power demanding requirements.
Even for commercial appliactions we now use PIC24s or PIC32s unless we are going to ten's of thousands of units and alternatives are significantly cheaper.
I don't see any point students learning out of date technologies. The PIC24 is powerful and flexible, easy to interface too and has lots of support for C programming in terms of APIs to help control its devices. Similar for the ARM. Most of our projects use PIC or Freescale 16bit processors, dsPICs for specialist multimedia projects (e.g. interfacing to Midi devices) and ARMs and PIC32s for more rigerous and power demanding requirements.
i did not understand what you mean by out of date.. just by working on some good technology and controllers makes people think simple controllers are out dated...
for your information ATMEL 89c51 is about 60% of the production of any atmel controller they produce till date...
without understanding timer -> if you teach capture and compare mode. its useless similarly if you dont teach address and data bus and prefer to teach amba , AXI or higher bus configuration no one can learn... thats my suggestion being in this field for 11 years and trained almost 50000 people.
there may be difference of opinion but let us close this here and try to help the poster with some solution....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
