Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

4-20 mA to 0-10 V Circuit Design (Isolated)

Status
Not open for further replies.
B

blacksnow

Junior Member level 2
Junior Member level 2
Joined
Mar 1, 2010
Messages
20
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Location
India
Activity points
1,432
How can i design a 4-20 mA to 0-10 Volts Circuit? (I don't want to convert it to 0-5V or 0-10V using 250 or 500 Ohm resistor)

Can i do it by converting 4-20 mA to some voltage signal using operational amplifier e.g. 2 to 12 Volt and then convert it to 0-10 V using Comparator circuit?

Assume 4 to 20 mA X k = 2 to 12 Volts (where k is the gain of opamp)

and then 2 to 12 Volts - 2 = 0 to 10 Volts. (Using Comparator)

If i am right then please suggest some suitable opamp IC for amplifier and comparator.

And if not then please suggest some other solution.

Thanks
 

A compatator is used to decide if a voltage is above or below a reference voltage, it has a bistable output, high or low. I'm assuming you are looking for a linear output so you'll need to use an opamp with an offset applied. Check out this thread https://www.edaboard.com/threads/1203/

Ray
 
I use IL300, it's linear optocoupler. So, you can make it isolated with just a few components.

See:


You can find 4-5 different application manuals by google with examples how to do it.

Mr.Cube
 
Last edited:
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top