Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] need help about hybire ring mixer

Status
Not open for further replies.
O

orkfire

Newbie level 4
Newbie level 4
Joined
Jul 5, 2010
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
China
Activity points
1,321
96_1297174068.jpg


hello everyone,i want to design a mixer use two diodes,so i chouse ring

hybire mixer,but i have some problem when designing it.
1.first,how can i deside the width of the circle and the radius.
2.what is the function of the two sector
 

Hello Orkfire,

Total ring lenght must be 1.5*lambda. Main idea is to provide LO phase difference 180 degrees between diodes. If assumed Z0=50 Ohm, suppose ring trace impedance must be 50*sqrt(2)=70.5 Ohm.
Sector is a radial stub (base element in microwave technique for ac blocking).
Have a look at Stephen's Maas "Microwave Mixers" book, there was a short explanation of hybrid ring mixer.
 
Last edited:
Many thanks for your help, I will try it.
 
Last edited:

yesterday i have used ADS to emulated it.i use 2.5GHz 14dbm as LO input and 2.4GHz 0dbm as RF input.and then it come out 4.9GHz -10dbm and unwanted 4.7GHz,4.8GHz ,5.0GHz.I wonder can it be eliminated .thanks
43_1297307752.jpg

84_1297307752.jpg
 

Some of the spurious are more than 30dB below from the wanted so is not a big issue, but you cannot use filters to eliminate them, because they are too close from the wanted.
Try to optimize the LO and RF levels to minimize these spurious, which actually are IM products.
Also try to put a LPF followed by a few dB's attenuator at the LO port, to be sure this is free of harmonics.
 
Hello, Orkfire.
Let me see you your ADS model? Probably via pm (i don't know, there are supported attachments upload through the pm).
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top