Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Iwatsu oscilloscope repair

Status
Not open for further replies.
S

sreekris

Newbie level 4
Newbie level 4
Joined
Dec 3, 2006
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,335
iwatsu oscilloscope repair

Hi,
I'm working on an Iwatsu SS-7810 (100MHz) oscilloscope. I have found two fried SMD transistors at position Q6 on the board where the BNC sockets are located. The only marking on the transistor is K51. Does anyone know the part number of this transistor or where I can locate a service manual for this oscilloscope. Thanks for the help.
 

iwatsu oscilloscope

Hello ,
You must to search (WSYWG) : "smd+codes" or "smd+marking+codes" or "smd+marking" on the www.google.com.
Good luck
ta2ctp
Safak.
 

iwatsu oscilloscope manual

Hi,
This path is same , another google.xxx
Exmpl : google.com - google.ca - google.com.tr etc....
Sincerely.
Safak..
 

iwatsu and repair

Do you have schematic(s) for Iwatsu oscilloscope?
I've a defective SS-7611, No HighVoltage
 

Hi
For Iwatsu SS7810 I found the St.by small source transformer fault . Where can I find something - FS 44238-21 write on Transformer , who sells spare parts for Iwatsu ?
Thank you
Costas
 

I have reeling again and now chopper works,
chopper FS 44238-21 data:
L1 = 310 turns with CU-em 0.18
L2 = 33 turns CU-em 0.35
L3 + L4 14 turns 22 turns simultaneously with CU-em 0.35
L5 = 10 turns CU-em 0.18
wbr.Costas
 
  • Like
Reactions: karesz

    K

    karesz

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top