Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help needed about CNC

Status
Not open for further replies.
E

Electronics_chaitanya

Member level 5
Member level 5
Joined
Oct 27, 2010
Messages
91
Helped
7
Reputation
14
Reaction score
5
Trophy points
1,288
Location
India
Activity points
1,985
Hello friends,

I m new in field of CNC and i m making 8' X 8' CNC wood cutter.I have some questions related to it.

1 Can i use stepper motor for it?

2 I m trying to drive stepper motor through l 297 and IRFZ44,I cant found IRLZ44 so can i connect as L297--->ULNXXXX--->IRFZ44?

3 what is minimum amount of current of motor i required?



i hope u give me some advice and suggestion for my project. Thank you.
 

Board 8'X 8' is no problem.
It depends how deep and how fast cut you want to make.
if you want to increas power, you can easily parallel the IRF mosfets
IRFZ44 is needed 8 to 10 + volts to drive.
ULNXXXX have sink outputs, say -ve (ground) output so they cant drive mosfet directly.
 
NEED HELP TOO...... I have a Plan on building a CNC Engraving machine and i'd to use DS89C450 as Microcontoller and 3 UC3770BN as stepper motor driver..... but I don't know how to interface this two parts and where will i connect every pins that UC3770BN has.......
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top