Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to interface photo diode with microcontroller ?

Status
Not open for further replies.
M

mishra12

Advanced Member level 2
Advanced Member level 2
Joined
Feb 18, 2009
Messages
672
Helped
136
Reputation
272
Reaction score
122
Trophy points
1,323
Location
some where left alone
Activity points
4,915
hi
i am doing laser light data and voice communication project .i have few but major difficulties in interfacing photo diode to 89c51 to rxd pin can any one provide me the working circuit diagram of it?
 

Use inverting amplifier ; replace input resistor with photo diode(reverese bias) and a feedback resistor of 10 M ohm for a binary (on -off output)
 
hi,

I have a same problem.in which i am using 10 photo diode each one is used for particular height.

I always want to get a output of this photo diode to give to my micro controller .and then i will give a output using some logic programming.

Now there is big confusion of basic circuit.In this thread its connected with op-amp.
bit is this also used for 670 nm red visible light photo diode ?

i am going to use this one for my photo diode.

Please guide me for this.

Thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top