Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Probleam in simulation with PROTEUS

Status
Not open for further replies.
P

piyush manavar

Member level 4
Member level 4
Joined
Jul 23, 2009
Messages
78
Helped
10
Reputation
20
Reaction score
8
Trophy points
1,288
Location
india
Activity points
1,827
hi all
i am continuing my project spot belling machine (may be many of you know this project because i had discussed a lot) and i think this is working properly.
i am testing this on PROTEUS software. but due to only 8 Mz frequency the output is not good enough so i need to increase crystal frequency but i don't know how to increase frequency in PROTEUS.

can any body tell me how i can increase frequency.
i am using ATmega128 in PROTEUS an in configuration of ATmega128 there is 8Mz internal RC option is working. the option for external crystal is not working. it shows some error.

so can any body tell me how can i solve my little problem.

Thanks

Regards
Piyush Manavar
 

Hi,
Select "External Crystal High Frequency", in the box below beside "Clock Frequency" where it's written "Default" type in "16MHz" or any frequency that you want. If your frequency is less than 8 MHz, select "External Crystal Medium Frequency" and then type in the required frequency.

Hope this helps.
Tahmid.
 
I use 0000 ext. clock in the fuse selector and then enter 16000000 (or any value) in the clock frequency property

Alex
 
alexan_e said:
I use 0000 ext. clock in the fuse selector and then enter 16000000 (or any value) in the clock frequency property

Alex
Click to expand...

Hi,
This is right, but only for simulation, as setting for ext clock means that you're going to have a pulse of 16MHz or whatever value at XTAL1 pin with XTAL2 not connected. This won't work for crystal in real life on hardware and is explained in the datasheet.

Hope this helps.
Tahmid.
 
hi everybody,
At here, you has 2 choice to use external clock, [0000 Ext.clock] and [1111 Ex High Freq], and then, on the right box of "clock frequency" you type the clock value that you want, for example : 16MHz or 16000000. Type the clock value into the crystal property .:cool:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top